REDA Helmet Lock Instructions
Locking your helmet has never been faster or easier....
1) Remove RED ball by pressing in the retainer detent and slide off ball
2) Thread tip of retainer through the D-ring, once through replace the red ball.
3) Now place the RED ball inside ANY locking lid or seat. Close the lid and lock it. The cable conforms to the weather strip under the lid.
DONE... The RED Ball is now trapped and locked inside the compartment and cannot come out
DONE... The black ball is permanently mounted to the cable and cannot come off. The D-Ring has a smaller opening than the diameter of the ball
NOTE: Make sure you hold the cable or helmet when you open the lid or your helmet will drop to the ground.
$24.95 ea
NOTE: IF you have a helmet with a quick release you will need the REDA T-Bar
1) Push the T-bar through the quick release
2) After red ball is removed thread the cable tip through the hole in the T-bar.
3) Slide the cable all the way through to the black ball. You can now lock you helemt just like the instructions above